Sugars & Sweeteners

Maltodextrin (Anhydrous)

Maltodextrin is a low-sweetness carbohydrate polymer (DE below 20) made by partial hydrolysis of starch. In gelato it is a solids builder: it raises total solids and improves body while adding little sweetness and about a third of sucrose's freezing point depression.

Balancing parameters

Per 100 g of product, verified against independent food-science sources (listed below).

ParameterValue
Total Solids95%
Water5%
Sugars95%
Fat0%
MSNF0%
Protein0%
POD (sweetening power)12.6
PAC (anti-freezing power)34.3

Typical use: Typically 1-5% of the recipe, occasionally up to about 6% in alcohol-heavy or low-sugar formulations where extra solids are needed.

Balance maltodextrin (anhydrous) in a real recipe

Free balancer · no signup wall · watch PAC, POD and Total Solids update live as you add it.

Open the balancer

How to use it in gelato

Maltodextrin is used mainly to raise total solids without over-sweetening or over-softening the mix. Because its POD is low (about 12.6 on the sucrose=100 scale) and its PAC is moderate (about 34 per 100 g of product, a third of sucrose), it firms body and reduces iciness while still moving the freezing curve a little. It is especially valuable in alcohol-heavy, low-fat or reduced-sugar recipes where PAC is already high but solids are short, though at a few percent of the mix its own PAC is no longer negligible and belongs in the calculation. The DE sets both coefficients: on a dry basis PAC is about 1.9 times the DE and POD about 0.7 times the DE, so higher DE grades depress the freezing point proportionally more and lower DE grades contribute more chew and less. Use it to fine-tune solids after the sugar blend and PAC target are set.

Origin & background

Maltodextrin is legally defined in the United States as a nonsweet nutritive saccharide polymer with a dextrose equivalent (DE) less than 20 (FDA 21 CFR 184.1444). It is produced industrially by controlled enzymatic or acid hydrolysis of starch, typically from corn, potato, tapioca or wheat, followed by refining and spray drying.

Frequently asked questions

Sources

More sugars & sweeteners ingredients

Substitutes for Maltodextrin (Anhydrous) →